Service manual

Avantra 36/44 Service Manual

4-22 Removal and Replacement

4.3.8 Cutter Motor

Tools Required: Phillips screwdriver, 5/64" allen wrench

Remove:

1. Remove the cutter assembly. See Section 4.3.7, Cutter Assembly.

2. Cut the tie wrap around the motor holding the wires in place.

Figure 4-15 Cutter motor.

➀–Cutter assembly. ➁–Cutter motor.

➃–Motor cam. ➄–Two 5/64" allen screws. ➅–Shaft. ➆–Coupler.

➇–Two 5/64" allen screws. ➈–Four phillips screws. ➉–Cutter Home Sensor.

11–Two phillips screws.

3. Twist the shaft at the end of the motor so that the 5/64" allen screws on the

coupler are visible. Refer to Figure 4-15.

4. Loosen the two (2) allen screws on the coupler and remove the motor

shaft. Refer to Figure 4-15.

5. Remove the four (4) phillips screws securing the cutter motor to the stand-

offs. Refer to Figure 4-15.

6. Loosen the two allen screws on the motor cam. Remove the motor from

the cutter assembly.

Replace:

1. Reverse the above procedure to re-install the cutter motor.

2. The cutter assembly should be checked for proper operation before the

outer covers are installed.

3. Turn the system on and launch the AVDIAG program from your PC.

6 97

1110