Service manual

Section I: Imagesetter

Removal and Replacement 4-21

Figure 4-14 Cutter assembly and SDM board.

➀–Cutter assembly. ➁–Two of four 3/16 " hex bolts.

➂–SDM board. ➃–Switch/sensor connector (J4).

5. Remove the rubber foam from the sides of the cutter assembly.

WARNING: Use two people to remove the cutter assembly.

CAUTION: The media entrance and exit guides on the cutter assem-

bly can be easily bent if they come into contact with a hard surface.

When working or placing the cutter assembly down, always face the

mounting plate (the plate that was attached to the system) in the

down position.

6. Remove the four (4) 3/16" hex screws, two (2) on the left and two (2) on

the right, securing the cutter assembly to the drum. Refer to Figure 4-14.

Replace:

1. Reverse the removal instructions to re-install the cutter assembly.