Service manual

Section I: Imagesetter
Removal and Replacement 4-9
4.3 Media Transport Removal/Replacement
Procedures
The following describes the media transport removal/replacement procedures.
4.3.1 Take-up Light Shield
1. Raise the front top cover.
2. Remove the top and middle panels. See Section 4.2.2, Top, Middle and
Bottom Front Panels.
3. Loosen the three thumb screws at the bottom of the light shield. Refer to
Figure 4-7.
4. Grab the shield by the handles. Refer to Figure 4-7. Pull out, then up.
Figure 4-7 Take-up light shield.
➀ –Take-up light shield. ➁ –Three thumb screws. ➂ –Handles.
1
3
2