Operation Manual

10cm
10cm
10cm
10cm
75mm
75mm
INTRODUCTION
INSTALLING BATTERIES
(1 )Open the battery compartment cover on the back side
(2)1nsert two 1 .5V batteries of AAA type with correct polarity
(3)Close the battery compartment cover on the back side
Notes on Using Batteries
The use of the wrong type of batteries may cause chemical
leaks and/or explosion.
Please note the following:
Only batteries of the same or equivalent type as recommended
are to be used. Always ensure that the batteries are inserted with
the positive and negative terminals in the correct direction as
shown in the batteries compartment. Different types of batteries
have different characteristics. Do not mix different types.
Do not mix old and new batteries. Mixing old and new batteries
will shorten battery life and /or cause chemical leaks from the
old batteries.
When batteries fail to function, replace them immediately.
Chemicals which leak from batteries may cause skin irritation.
If any chemical matter seeps out of the batteries, wipe it up
immediately using a dry cloth.
Due to varying storage conditions, the battery life for
the batteries included with your unit may be shortened.
If the remote control is not used for a long period of time,
remove the batteries.
Notes on using the Remote control:
Do not strike or drop the remote.
Do not expose the remote control to liquids and do not
place it in humid environment.
Do not install or place the remote control in direct sunlight.
The heat may damage the remote control.
INSTALLATION
STAND INSTALLATION
Wall Mount: Horizontal installation
(1 ) Secure the wall brackets with the bolts (not provided as parts of the product, must be
purchased separately) on the wall. Match the height of the bracket that is mounted on
the wall. The wall bracket is of normal dimension. Please see the position of the wall
brackets bolts in the following picture. Please adjust the bolts of the wall brackets
according to the product dimensions. Detailed installation instructions are available from
your dealer; please refer to the setup guide.
(2) Remove the table stand of the TV when install the TV on a wall as follow:
(Please refer to page 62 & 63 )
(3) For proper ventilation, allow a clearance of 10cm on each side from the wall.