Installation guide

8.
Update the value of RemoteSignalHost with the host name or IP address of the computer in
the previous-release version of IMPAX that is running the study-status-relay service.
9. Save and close the file.
10. In the command prompt, type
install_study_status_relay_service.bat
If a log4net error is returned, you can safely ignore this message.
To diagnose other errors or check status, consult the Study.Status.Relay.log file located in the
study-status-signal-relay folder.
If ready to use the service, proceed to the next topic, Running the Cross-Cluster Dictation Interlock
tool (refer to page 58).
Running the Cross-Cluster Dictation Interlock tool
(Topic number: 47379)
7.
Before it can be run, the Cross-Cluster Dictation Interlock tool must be installed and configured.
The Cross-Cluster Dictation Interlock (CCDI) tool synchronizes both the dictation status and the
claim status of studies between the previous version of IMPAX and IMPAX 6.5.3, when these are
running in parallel—such as may happen when using a training server, when using a traveling server,
or if planning to run the upgraded IMPAX cluster alongside the previous-version IMPAX cluster
for a transition period.
Synchronization of the claim status of studies occurs only between versions of IMPAX that support
shared workflows from which radiologists can then claim ownership of studies.
Note:
Do not confuse CCDI with Dual Cluster Claim and Assign (DCCA), which allows two active
clusters of the same version (IMPAX 6.5.2 or later), running in parallel, to synchronize study
status notifications and claim and assign messages between the two clusters as though they
were one. For details, see “Understanding Dual Cluster Claim and Assign” (topic number
128193) in the IMPAX 6.5.3 Application Server Knowledge Base.
To run the Cross-Cluster Dictation Interlock tool
1. On the 6.5.3 Application Server where the Relay service is running, open a command prompt.
2. Type the following command:
net start StudyStatusRelayService
3. Exit the command prompt.
AS300 Upgrade and DAA Consolidation Guide—IMPAX 5.2 or 5.3 to IMPAX 6.5.3 58
Agfa Company Confidential—Subject to Non-Disclosure Obligation