Installation guide

CAUTION!
Ensure that the Logical Volume is empty before deleting it. If it is not empty, create a store job to
archive the images in the Logical Volume.
To clear the Logical Volume
1. In the Administration Tools, switch to the Setup tab.
2. Select Archive Manager.
3. Select the Logical Volume and click Close.
4. At the Close Volume prompt, click Yes.
5. Ensure that the Archive queue is halted (refer to Halting the archive queue (refer to page 71)).
6. Delete the Logical Volume folder and files from the drive.
The Logical Volume folder and files are automatically re-created by IMPAX.
Disabling the server15.
To complete the pre-upgrade procedures, disconnect the server from the network and stop and remove
the mvf services.
To disable the server
1. Disconnect the server from the network.
2. If you did not run stopall.bat to delete the old log files, run stopall.bat.
3. To remove the mvf services, browse to C:\mvf\bin\ and run removeall.bat.
Uninstalling and disabling software on the original server16.
Finally, on the original server, uninstall the IMPAX packages and SQL Server, and disable the associated
services.
Uninstalling IMPAX packages
Uninstall the IMPAX packages on the original server. The necessary packages will be reinstalled after.
To uninstall IMPAX
1. Open Control Panel.
2. Select Add/Remove Programs.
3. Select AGFA IMPAX 6.3.
4. Click Change/Remove.
IMPAX 6.3 AS300 Installation Guide 75