Installation guide

Enabling and configuring CD-R or DVD-R archives
• Install the archive according to the manufacturer’s instructions. Enable and configure it to make
a connection with IMPAX.
• After following the manufacturer’s instructions for setup, ensure that the archive is left powered
on. During the next system restart, the IMPAX computer automatically detects the archive and
establishes a connection.
• If you manually stop the archive services, you must restart the server so the services start cleanly.
• If you are using a jukebox archive, all drives must be enabled. Fill all of the jukebox magazines
with blank media. On startup, the archive initializes itself and examines all the media in the
magazines. This initialization may take several hours, depending on the amount of media;
however, if you wait until after IMPAX is started, you can only fill the jukebox one disk at a time
through the mailslot. Therefore, we recommend that all magazines be filled before the archive
is started.
CAUTION!
After you have filled the jukebox with media, keep the jukebox key switch in the locked position.
If the key switch is in the unlocked position while the archive is being controlled by the IMPAX
software, some archive operations may fail. Unlock the archive only for specifically required
access; for example, to add or remove disk magazines or to change the operational functions.
• If you are using a DRM-3000 or DRM-7000 jukebox, some of the jukebox’s optional functions
must be configured using the operation keys on the front of the jukebox. For additional details
on each of the settings under Option submode, refer to the DRM-3000 or DRM-7000 Operating
Instructions.
To configure the operational functions
1. Unlock the archive.
2. Press FUNCTION.
3. Press until you see Option submode.
4. Press ENT.
5. Configure the settings as specified in the table that follows:
Settings
DRM-7000DRM-3000
ONONAuto probing
OFFOFFHot start
ONONAuto eject
OFFOFFHyper I/E
IMPAX 6.3 AS300 Installation Guide 36