Installation guide

Note:
Throughout this document it is assumed that a CD device is assigned to drive D, and that the drive
letters and names shown here are used. The volume letters and labels on your system may differ from
those used here.
Configuring labels for jukebox CD-R and DVD-R archives
Configure the labels for the jukebox CD-R and DVD-R archives on single-host or Archive Servers.
To configure labels for jukebox CD-R and DVD-R archives
1. Select Start > Administrative Tools > Computer Management.
2. Under Storage, select Disk Management.
3. For each reader and writer:
Right-click the device and select Change Drive Letter and Paths.
Click Change.
Assign letters as shown in the table that follows and click OK.
4. To confirm that the drive letter should be changed, click Yes.
Used forLetter
Reader 1X
Reader 2Y
WriterZ
Creating the logical volumes
Before proceeding, ensure that you have determined how to partition the disks. Refer to Information
to consider when partitioning disks (refer to page 30).
Use the Windows Administrative Tools to create new disk partitions.
To create the logical volumes
1. Select Start > Administrative Tools > Disk Management.
2. In Windows Disk Management, right-click the unallocated portion of Disk 0 and select New
Partition.
3. Follow the New Partition Wizard to create an extended partition using the remaining space on
the disk.
4. If you have more than one disk, for each additional disk, follow steps 3 and 4 to create the extended
partition on the disk.
IMPAX 6.3 AS300 Installation Guide 31