Installation guide

Action
Check subpackage installations (refer to page 64) by referring to response files
Configure Data Execution Prevention (DEP) (refer to page 66)
Upgrading IMPAX from an AS300 single-host configuration to
an AS300 multi-host configuration
To realize greater workflow volume and enhanced system performance, you may decide to upgrade
your IMPAX system from a single-host to multi-host configuration. Perform the database backup, the
installs, and the uninstalls in the order listed in the table that follows.
Action
Perform the pre-upgrade procedures including backing up the database on the original
server (refer to page 69). Refer to Preparing to upgrade from a single-host to multi-host
configuration (refer to page 69).
Install the hardware and software on the new Database Server (refer to page 26). Refer to
Installing hardware and software on an AS300 server (refer to page 26).
Install IMPAX on the new Database Server including restoring the database and MVF services
(refer to page 52). Refer to Installing IMPAX on a dedicated AS300 Database Server (refer
to page 52).
Install the IMPAX Archive Server packages on the original server (refer to page 58). Refer
to Installing IMPAX on the Archive Server (refer to page 58).
If required, install hardware and software on the dedicated Network Gateway server (refer
to page 26). Refer to Installing hardware and software on an AS300 server (refer to page
26).
If required, install the IMPAX Network Gateway packages (refer to page 62). Refer to
Installing IMPAX on the Network Gateway (refer to page 62).
IMPAX 6.3 AS300 Installation Guide 25