Installation guide

Action
If required, change the default Curator INI settings (refer to page 19)
Configuring IMPAX on a dedicated AS300 Database Server
You must configure the Database Server in the order listed in the table that follows. For more complete
instructions, refer to Configuring an AS300 single-host Server or dedicated Database Server (refer to
page 9).
Action
Perform the initial database backup (refer to page 9)
If required, configure database backup times (refer to page 10)
Configure SQL Server character support (refer to page 11)
Identify any remote PACS in IMPAX (refer to page 13)
Set up the image and web caches (refer to page 14)
Change the default log file location (refer to page 30)
Change the Administration Tools log paths (refer to page 17)
Create IPSEC filters to allow access to specified hosts (refer to page 31)
Configuring IMPAX on an AS300 Archive Server
You must configure the Archive Server in the order listed in the table that follows. For more complete
instructions, refer to Configuring the Archive Server or Network Gateway (refer to page 22).
Action
Set up the image and web caches (refer to page 14)
Configure PACS Store and Remember archiving (refer to page 22), if using this form of
archiving
Configure an HSM archive (refer to page 28), if applicable
If you have installed the Scavenger component, install and start the Scavenger service (refer
to page 29)
If applicable, move the DVD-R VOLUMES partition (refer to page 28)
Change the default log file location (refer to page 30)
Create IPSEC filters to allow access to specified hosts (refer to page 31)
Where required, change the default Curator INI settings (refer to page 19)
IMPAX 6.3 AS300 Configuration Guide 7