Installation guide

OptionsScreenWizard
Tunnel EndpointSecurity Rule
Wizard
1. Accept default selection, This rule does not
specify a tunnel.
Network TypeSecurity Rule
Wizard
1. Change to Local area network (LAN).
Authentication MethodSecurity Rule
Wizard
1. Accept the default authentication method.
IP Filter ListSecurity Rule
Wizard
1. Click Add.
IP Filter ListSecurity Rule
Wizard
1. In the Name field, type an appropriate name for
the filter.
Example: Domain Controller Filter List
2. In the Description field, type an appropriate
description for the filter.
Example: Open access to the domain controller
3. Ensure that Use Add Wizard is enabled.
4. Click Add.
The IP Filter Wizard is launched.
IP Filter Description and
Mirrored property
IP Filter Wizard 1. Add an appropriate description.
Example: Open Access to the Domain Controller
2. Enable Mirrored.
IP Traffic SourceIP Filter Wizard 1. From the Source address list, select My IP
Address.
IP Traffic DestinationIP Filter Wizard 1. From the Destination address list, select one of:
• A specific DNS Name—If the hostname is
known.
• A specific IP Address—If the IP address is
known.
2. Type the fully qualified hostname or IP address.
3. If you typed a hostname and received a security
warning about creating a filter using the
hostname, review the content of the message for
correctness and then, to create the filter, click Yes.
IP Protocol TypeIP Filter Wizard 1. From the Select a protocol type list, accept the
default selection for Any.
CompletingIP Filter Wizard 1. Click Finish.
IMPAX 6.3 AS300 Configuration Guide 32