Installation guide

This step is necessary because studies can be received from a machine that belongs to the PACS
and that the PACS Store and Remember archive stores to and remembers from, but that is not
the store or remember AE.
Note:
For the PAP to automatically register studies as PACS archived, at least one open PACS volume
must exist. When a PACS Store and Remember archive is installed, ensure that it works by
storing a study to the archive, then retrieving it back from the archive.
To configure a source to send to the PAP component
1. If the source is another IMPAX system, log into the source Administration Tools.
2. On the Setup tab, select Network Management.
3. Create a new station with a unique ae_title and specify the host containing the PAP and port
9104.
4. Click Save.
To configure the remote AEs that belong to the PACS
1. Determine the AE titles that belong to the PACS that the PACS Store and Remember archive stores
to and remembers from.
2. Ensure that the AE title matches an ae_title in the map_ae table.
3. Log into CLUI.
4. To add the entry to the map_ini table, type:
insert into map_ini (ini_section, ini_key, ini_value) values ('<scu_ae_title>',
'PACS_ARCHIVE_AE_TITLES', '<other_ae_titles>')
where <scu_ae_title> is the AE title of the machine with the SCU drive queue and
<other_ae_titles> is the comma-separated list of AE titles (may or may not include the PACS
Store and Remember store or retrieve AE).
Note:
Ensure that no spaces appear before or after commas in the comma-separated list of AE titles.
Also, when configuring a PACS for mirroring using PACS Store and Remember archiving, set up
each PACS with another local archive besides the PACS Store and Remember archive.
To perform other PAP configurations
1. Disable HIS verification.
By default, the PAP is configured to perform HIS verification.
2. Change the PAP so that it routes incoming studies.
By default, the PAP is configured to not route incoming studies.
IMPAX 6.3 AS300 Configuration Guide 26