Installation guide

6. In the Host field, type the hostname or IP address.
7. Click Save.
8. Switch to the Capabilities tab.
9. From the list at the bottom of the manager, select the external PACS archive.
10. Under Station Type, select PACS.
11. Under Server is Allowed to, select Query/Retrieve from Station.
12. Click Save.
14. Register the PACS Store and Remember archive services in Windows (refer to page 24).
Registering PACS Store and Remember archive services in Windows
Designate the server that will perform the PACS Store and Remember archiving. Often this is the server
running the Network Gateway software.
To register PACS Store and Remember archive services in Windows
1. Open Control Panel.
2. Select Services.
3. Make sure the Service Class User service is started.
4. Close the Services and Control Panel windows.
5. At a command prompt, type:
cd \mvf\bin
install_pacs.bat <AE title of the PACS Store and Remember archive> <AE Title of the external
PACS archive> <AE Title for retrieve jobs on the external PACS archive>
6. Open Control Panel.
7. Select Services.
8. Right-click the Service Class User service and, if running, select Stop.
9. Right-click the Service Class User service and select Start.
10. Close the Services and Control Panel windows.
Testing PACS Store and Remember archiving
Test the PACS Store and Remember archive to make sure the services were registered properly.
To test that the archive was set up correctly
1. To confirm that the external archive is set up correctly in IMPAX, check that the external archive
is listed in the /etc/hosts file.
2. To confirm that the external archive can be accessed, ping the external archive using the hostname
or IP address.
IMPAX 6.3 AS300 Configuration Guide 24