Technical information

21Chapter 1 — Preparing the scanner
4. Press the upper part and the bottom plate of the transparency
holder together until you hear a click.
5. Place the transparency holder in the transparency-holder frame.
Make sure that the pins of the holder are inserted completely in
the holes of the frame (see Figure 1-11). The transparency holder
should be in full contact with the protection foil of the
transparency-holder frame.
6. Place the frame in the top left corner of the glass plate.
Make sure that the slot in the frame (for lamp calibration) is at the
left side. Always cover unused neighbouring holes of the frame
with the round hole covers. This eliminates the visibility of stray
light and reflections.
A4
A5
AGFA
Figure 1-11
Placing the frame
with transparency holders
on the scanner