Technical information

20Chapter 1 — Preparing the scanner
Using the optional transparency holder frames and
transparency holders
The holders keep the originals perfectly flat between two anti-Newton
glasses, thus guaranteeing optimum sharpness.
To insert transparencies in the transparency holders and the holders in
their frames, follow this procedure:
1. Place the transparency holder frame, with the protection foil
down, in the upper left corner of the scanner’s glass plate.
2. Press the two plastic buttons on the top of the required
transparency holder to unlock the upper and lower part of the
holder (see Figure 1-9).
3. Place the transparency (without frame) between the upper part
and bottom plate (see Figure 1-10).
To avoid wrong reading, make sure that the emulsion side of the
transparency faces upwards when the transparency holder is
placed in its frame.
a
Figure 1-9
Unlocking the transparency holder
Figure 1-10
Placing the transparency in the holder