User's Guide Digital Camera CL20
Table Of Contents
- Introduction
- Chapter 1: Getting to Know Your Camera
- Chapter 2: Recording a Still Image
- Chapter 3: Transferring Images to Your PC
- Chapter 4: Organizing Images Using PhotoWise
- Chapter 5: Ordering Prints Over the Internet Using AGFAnet Print Service
- Chapter 6: Using the ePhoto CL20 for Video Applications
- Appendix A: Troubleshooting and Support
- Appendix B: Camera Specifications
Chapter 2: Recording a Still Image 20
Chapter 2: Recording a Still Image
#
Note: Do not forget to insert batteries as described in Inserting Batteries.
1
Slide the REC/OFF auto return switch towards REC.
Wait until the Green Action Indicator stops blinking.
2
Change the camera settings.
3
Frame the image in the viewfinder.
4
Press the Shutter button and hold still your camera until you hear a beep.
The action indicator blinks until the image is stored in the camera’s (or external) memory.
The moment the action indicator stops blinking you can record another image.
#
Note: The camera shuts down after one minute when no button is pressed.
Tips to Record Images
!
The number on the display indicates the number of images that still can be recorded.
!
While recording an image, hold still your camera until you hear a beep.
!
To obtain sharp images, do not record images closer than 65 cm (25.6“).
!
Be aware that the built-in flash only ranges from 1 m to 3 m (3.3 ft to 9.8 ft).
!
Preset your camera to High or PhotoGenie resolution if you intend to print the image.
!
Preset your camera to Low resolution if you intend to use the image in internet or e-mail
applications.