User Manual Part 2

139
2852 A EN 20070205
DRYSTAR AXYS
To overrule the Film Identification tag of the film pack
If the “Overrule RF-tag Reading” setting is active, you can overrule the Film
Identification tag setting of the current film pack. In this case you can continue
printing using a limited Maximum Density.
1 In case the Drystar AXYS does not start printing after inserting a new film pack,
check if this film pack is inserted correctly.
If the film pack is inserted correctly and the Drystar AXYS does not resume printing,
the following message will appear:
2 To continue with the current (unidentified) film pack, press the Continue but-
ton.
The following message is displayed:
If you wish, you can try again to re-insert the current or an other film pack. Open the
input tray to initiate the loading sequence. If you re-insert a film pack, the
Drystar AXYS will perform the check sequence.
Note: Only your local service organization has the possibility to enable the
“Overrule RF-tag Reading” setting!
Remove and re-insert
film pack -including
protective sheet-
properly. follow
loading instructions
Please INSERT
CURRENT FILM PACK or
call service.