User Manual Part 2

129
2852 A EN 20070205
DRYSTAR AXYS
Clearing of film jams
A film jam can be situated either:
Q In the input tray section. Refer to “Film input tray jams” on page 130 .
Q In the top section. Refer to “Film transport jams (clearing from the top)” on
page 133 .
Jams can be caused by:
Q Opening the top cover or input tray while a film is actually being printed. Refer
to “Unauthorized opening of the printer” on page 136 .
Q Loading films incorrectly. Refer to “Film identification problems” on page 137 .
Caution: Film jam removal or cleaning the printer thermal head can be
done without switching the power off. Nevertheless, care should be
taken and the following instructions should be respected:
WARNING: Never reuse a jammed film. This may cause damage to
the thermal head and/or dust problems.
Film feed jams (clearing
from the input tray)
Film transport jams
(clearing from the
top section)