User Manual Part 2

123
2852 A EN 20070205
DRYSTAR AXYS
Cleaning the print head
Procedure
1 Press the Key-operator key to enter the key-operator mode.
2 On the key-operator main menu, press the Down key five times, followed by the
Confirm key to select ‘Calibration’.
3 On the Select calibration menu, press the Down key, followed by the Confirm
key to select ‘Clean therm. head’.
4 The ‘Thermal head cleaning’ screen will give step-by-step instructions on what
to do:
WARNING: Print head cleaning must be done when image quality
problems occur.
5 Restore config.
6 Calibration
7 Service Actions
8 Quality Control
9 Installation