User Manual Part 1

16
2852 A EN 20070205
DRYSTAR AXYS
The status indicator LED
On the right side of the display, an LED indicates the status of the Drystar AXYS.
The control buttons
One control button has been provided:
Colour/Light Status Action
Green Constant Ready (stand-by) Proceed
Blinking Busy or in key-opertor
mode
Wait
Red Constant Warning status Check the display for
messages.
Refer to “Checking the
status indicator LED”
on page 241 of the Ref-
erence manual.
Blinking Error status
Table 1: Status indicator LED
Power/Reset button
• To power on or off the printer.
• To reset the printer.
Table 2: Control buttons
WARNING: Do NOT press the Power/Reset button without first
following the procedure to stop printing when the Drystar AXYS is
printing a film. Refer to “Switching off the Drystar AXYS” on page 63