User Manual

61
2831A EN 20041201 Advanced operation (key-operator mode)
DRYSTAR 5302 USER MANUAL
Cleaning the print head
To clean the print head:
1 Press the Key-operator key to enter the key-operator mode.
2 On the key-operator main menu, press the Down key five times, followed by the
Confirm key to select ‘Calibration’.
3 On the Calibration menu, press the Down key, followed by the Confirm key to
select ‘Therm. Head clean.’.
4 The ‘Thermal head cleaning’ screen will give step by step instructions on what
to do:
Print head cleaning must be done when image quality problems occur.
1 Show settings
2 Change settings
3 Print image
4 Save configuration
5 Restore config.
6 Calibration
7 Service actions
8 Quality control
9 Installation
KO
CA
CALIBRATION
1 Film Calibration
2 Therm. Head clean.
THERMAL HEAD
CLEANING
Open top cover
CA