User Manual
Table Of Contents
- Table of contents
- Introducing the Drystar 5302
- Basic operation (Operator mode)
- Advanced operation (key-operator mode)
- Equipment information sheet
- Quality Control Charts
43
2831A EN 20041201 Basic operation (Operator mode)
DRYSTAR 5302 USER MANUAL
Checking the correct position of a film in the input tray
You can verify that the film is properly loaded by watching the lower right corner of
the films in the input tray. The rounding of this corner should be smaller than the
other three corners. This is also indicated on the sticker at the right side of the input
tray cover.
When a new film is loaded, the Film Identification tag is read and the printer
settings are automatically adjusted. The Film Identification tag is located on the
protective sheet on the backside of the film pack. The figure below shows the film
pack upside down.