User Manual
Table Of Contents
- Table of contents
- Introducing the Drystar 5302
- Basic operation (Operator mode)
- Advanced operation (key-operator mode)
- Equipment information sheet
- Quality Control Charts
23
2831A EN 20041201 Introducing the Drystar 5302
DRYSTAR 5302 USER MANUAL
Working with Compact flash cards (CF-card)
The Drystar 5302 is equipped with an external CF-card slot.
A CF-card has the following physical characteristics:
• a flat surface on one side (there is also often a label present),
• a small rim on the other side,
• connector holes on the opposite side of the rim side.
Inserting a CF-card
To insert a CF-card in the Drystar 5302 (the slot is located at the rear side):
1 Hold the CF-card vertically with the connector holes in front of the slot and with
the flat surface pointing to the left.
2 Insert the CF-card gently into the slot and push it until the unlocking lever
underneath the slot comes out.
If you cannot push the CF-card completely into its position, this means that you
have to turn it 180 degrees (while keeping the connector holes faced to the slot).
1
2