User's Manual Part 2

89
2920B EN 20031206
Changing the interpolation
1
Perform steps 1 to 3 of the ‘Changing Image quality settings for a modality’
procedure on page 87 to select the modality and choose ‘Select other’.
The ‘Select for Modality’ screen is displayed:
2 In the ‘Select for Modality’ screen, press the Down key, followed by the
Confirm key to select ‘Interpolation’.
The ‘Interpolation’ screen is displayed:
3 Press the up/down key to select the desired interpolation setting for this
modality.
$ If you select “Cubic Hi-Res” the following screen will appear, allowing you to
adjust the smoothing factor:
Enter the smoothing factor value by means of the arrow keys. Refer to ‘Data entry’
on page 27. Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
Select for
Modality16char:
1 Look-up table
2 Interpolation
3MaxD
CS
Select for
Modality16char:
1 Replication
2 Bilinear
3 None
4 Cubic Hi-Res
5 CubicBell
CS
Enter smoothing
parameter:
advised value = 2.50
range [-5.00-0.00]
enter absolute value
y.yy