User's Manual Part 2

85
2920B EN 20031206
Changing general image quality settings
1
Perform steps 1 and 2 of the ‘Accessing the Change settings menu’
procedure on page 59.
2 On the ‘Change settings’ screen, press the Down key three times, followed by
the Confirm key to select ‘Image quality’.
The following screen will appear:
3 Press the Confirm key to select ‘General setting’.
The ‘General setting’ screen is displayed:
This setting is by default set to ON and will apply to every modality. The currently
active setting is indicated with a ‘*’.
" For more information on film calibration settings: refer to ‘Understanding
the calibration policy’ on page 102.
4 Press the up/down key to select the film calibration default.
When the setting is ON, the Drystar 5300 will ask you to enter the calibration
frequency:
Enter the calibration frequency by means of the up/down key. Refer to ‘Data entry’
on page 27.
5 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
1 General setting
2 Def. densitometer
3 Modality16char
4 Modality16char
5 etc...
CS
Select default
film calibration
*ON
OFF
CS
Select Frequency
Every 01 film packs