User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
70
2920B EN 20031206
Changing the hostname
1
Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure
on page 59.
2 On the Change settings menu, press the Down key twice, followed by the
Confirm key to select ‘Network (DICOM)’.
The ‘Network (DICOM)’ screen is displayed:
3 In the ‘Network (DICOM)’ screen, press the Down key, followed by the
Confirm key to select ‘Hostname’.
The ‘Hostname’ screen is displayed:
If the Hostname has already been assigned, it will be shown on the display.
4 Change the hostname by means of the arrow keys. Refer to ‘Data entry’ on
page 27. Make sure not to enter more than 16 characters.
5 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
1 Printer AE_Title
2Hostname
3 Domain name
4 Printer IP address
5 Serv. Host IP add.
6Netmask
7 Router IP address
8 Remove modality
9 Add modality
10 Alert mailing
CS
Hostname:
[Drystar ]
(max. 16 char)