User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
65
2920B EN 20031206
Changing the input tray settings
Changing the film view
Using the following procedure you can change the film view.
1 Perform steps 1 and 2 of the ‘Accessing the Change settings menu’
procedure on page 59.
2 On the Change settings menu, press the Down key, followed by the Confirm
key to select ‘Input tray’.
The ‘Input tray’ screen is displayed:
3 Press the Confirm key to select ‘Film view’.
The ‘Film view’ screen is displayed:
The currently active film view is marked with a ‘*’.
4 Press the up/down arrow keys to select the film view.
5 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
1 Film view
2 Film type
3 Film format
CS
1*Normal
2Back