User's Manual Part 2

63
2920B EN 20031206
Changing the beep on empty tray settings
You can change the way the Drystar 5300 warns the user of an empty input
tray situation.
1 Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure
on page 59 to select the ‘General’ screen.
2 On the ‘Change settings’ screen, press the Confirm key to select ‘General’.
The ‘General’ screen is displayed:
3 On the ‘General’ screen, press the Down key twice, followed by the Confirm
key to select ‘Beep on empty’.
The ‘Beep on empty tray’ screen is displayed:
" ‘No’ means that the printer will produce no audible signal when the input
tray is empty.
" ‘5 times’ mains that the printer will sound 5 beeps when the input tray is
empty.
" ‘many’ means that the printer will continue to beep as long as the input
tray is empty.
The currently active setting is marked with a ‘*’.
4 Press the up/down arrow keys to select the desired setting.
5 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
1 Date & time
2 Language
3 Beep on empty
(site specific data
via browser only)
CS
Beep on empty tray
No
* 5 times
many