User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
62
2920B EN 20031206
Changing the language
1
Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure
on page 59 to select the ‘General’ screen.
2 On the ‘Change settings’ screen, press the Confirm key to select ‘General’.
The ‘General’ screen is displayed:
3 On the ‘General’ screen, press the Down key, followed by the Confirm key to
select ‘Language’.
The ‘Language’ screen is displayed with the available languages (only the Western
languages are shown in this manual; contact Agfa for the latest Drystar 5300
language availability status):
The currently active language is marked with a ‘*’.
4 Press the up/down arrow keys to select the desired language.
5 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
1 Date & time
2 Language
3 Beep on empty
(site specific data
via browser only)
CS
1* English
2 Français
3 Deutsch
4 Nederlands
5 Dansk
6Suomi
7 Svenska
8Norsk
9 Italiano
10 Português
11 Español
etc..