User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
54
2920B EN 20031206
Viewing default densitometer information
1
Perform steps 1 and 2 of the ‘Accessing the Show settings menu’ procedure,
on page 49.
2 On the Show settings menu, press the Down key three times, followed by the
Confirm key to select ‘Image quality’.
The following screen will appear:
3 Press the Down key, followed by the Confirm key to select
‘Def. densitometer’.
The name of the default densitometer is displayed:
" All densities shown on the Drystar 5300 display are calculated according
to the response of the selected densitometer. Refer to ‘Density response
of Drystar media’ on page 106.
4 Press the Confirm key to return to the Image quality menu.
5 In the Image quality menu, press the Escape key to return to the Show
settings menu.
SH
1 General
2 Def. densitometer
3 Modality16charac
4 Modality16charac
5 etc...
Default
densitometer:
MacBeth TR924
SH