User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
42
2920B EN 20031206
Checking the correct position of a film in the input tray
" You can verify that the film is properly loaded by watching the lower right
corner of the films in the input tray. The rounding of this corner should be
smaller than the other three corners. This is also indicated on the sticker
at the right side of the input tray cover.
" When a new film is loaded, the Film Identification tag is read and the
printer settings are automatically adjusted. The Film Identification tag is
located on the protective sheet on the backside of the film pack. The
figure below shows the film pack upside down.
1
3
2
4
5
6
X
XX
X
XX
XXX
X
XX
X
XX
X
X
XX
XXX
XX
X
X X
X
XXX
X
X
X
XX
XX
X
XX
X
XX
X
XX
X
XXXXXX
XX
XX
X
X
XX
XX
XX
XX
XX
X
XX
X
XX
X
XX
X
X
X
XX
X
X
X
XX
X
X
XX
XXX
XXXXXX
XX
XX
X
X
XX
XX
X
XX
X
XX
XX
X
X
X
XXX
X
X
XXX
X
XX
X
X
XX
X
XX
X
XX
XX
XX
X
X
XX
XX
X
XX
X
XX
XXX
X
XX
XX
X
X
X
XXX
X
X