User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
37
2920B EN 20031206
When the Drystar 5300 is printing or calculating and the input
tray is empty:
1
The display shows the following message:
2 Wait while the printer finishes printing any current jobs.
When the film path is cleared, proceed with step 3.
When the Drystar 5300 is in the ready state and the input tray is
empty:
3
The display shows the following message:
4 Open the input tray.
To avoid possible film jams, make sure to open input tray all the way.
Empty input tray
Do not open tray yet
Get new film pack
Flashing
Flashing
Empty input tray
OK to open the
input tray
Flashing
Flashing
1
3
2
4
5
6
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
X
X
XX
X
X
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXXX
XXXXXX
X
X
XXXX
XXXX
XXXXX
X
XXXXXX
XXXX
XXXXXX