User's Manual Part 2

28
2920B EN 20031206
Switching on the Drystar 5300
" Before switching on the Drystar 5300, read the safety instructions. Refer
to ‘Safety precautions’ on page 8.
Follow the procedure below to ensure proper startup of the Drystar 5300 and
to check that everything is working correctly.
1 Check that the power cord is plugged in and then switch on the printer by
pressing the Power/Reset button.
On the display, the following message is displayed. After a short while, a progress
indicator will show the proceeding of the self-test.
• If anything goes wrong during the self-test, refer to ‘Startup errors’ on page 185.
2 The printer is ready for operation:
• If, on the front panel display, the READY message is shown, the status indicator
LED is constantly green.
" It takes 13 minutes (starting up of the Drystar 5300 and heating up of the
thermal print head) before you can start printing. The display will inform
you that the printer is warming up:
Please WAIT
Self-test
proceeding
62%
READY
WARMING UP
Please wait