User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
21
2920B EN 20031206
Working with Compact flash cards (CF-card)
The Drystar 5300 is equipped with an external CF-card slot.
A CF-card has the following physical characteristics:
• a flat surface on one side (there is also often a label present),
• a small rim on the other side,
• connector holes on the opposite side of the rim side.
Inserting a CF-card
To insert a CF-card in the Drystar 5300 (the slot is located at the rear side):
1 Hold the CF-card vertically with the connector holes in front of the slot, and
with the flat surface pointing to the left.
2 Insert the CF-card gently into the slot, and push it until the unlocking lever
underneath the slot comes out.
" If you cannot push the CF-card completely into its position, this means
that you have to turn it 180 degrees (while keeping the connector holes
faced to the slot).