User's Manual Part 2

183
2920B EN 20031206
If the film pack is inserted correctly and the Drystar 5300 does not resume printing,
the following message will appear:
2 To continue with the current (not identified) film pack, press the Continue
button.
The following message is displayed:
$ If you wish, you can try again to re-insert the current or an other film pack.
Open the input tray to initiate the loading sequence. If you re-insert a film
pack, the Drystar 5300 will perform the check-sequence.
3 Press the Confirm button.
If the “Overrule RF-tag Reading” Setting is active, the following message is
displayed:
" If the “Overrule RF-tag Reading” Setting is not activated, the following
message will be displayed:
" In this case, press the Confirm key to initiate the loading procedure again
or call your local service organization to enable the “Overrule RF-tag
Reading” Setting.
No Identification
code detected for
current film pack
Remove and re-insert
film pack -including
protective sheet-
properly. Follow
loading instructions
No Identification
code detected or
Read error in tray.
Please insert
correct film pack or
Call Service.
Code Exxxxx
Overrule of
identification code
is active.
MaxD is limited due
to safety reasons.
No Identification
code detected.
Printing is disabled
Re-enable printing
by inserting correct
film media pack