User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
172
2920B EN 20031206
The Drystar 5300 does not print
Reset of the printer
The Power/Reset button restarts the printer after a software failure or an
error. Refer to ‘Switching off the Drystar 5300’ on page 30
.
Checking the connections
" Regularly check all electrical connections. When interference occurs with
other devices, consult your local service organization.
If you are unable to get the printer to respond, the problem may be caused by
a fault in the connections. In this case, check that all connectors and cables
are firmly attached to the printer.
" Call your local service organization in case cables are disconnected. The
user is not allowed to add or remove any connectors.
Powering off the printer with unprinted images in memory may result in
image loss!