User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
159
2920B EN 20031206
Transport after installation
The Drystar 5300 is quite compact, so moving the printer over a short
distance - if required - can be done in a convenient way.
" Refer to ‘Safety precautions’ on page 8.
• The Drystar 5300 should always be transported by two persons,
• Never lift the Drystar 5300 by the output tray,
• Make sure the Drystar 5300 is placed on a stable, hard surface table.
1 Switch off the Drystar 5300 (refer to ‘Switching off the Drystar 5300’ on
page 30).
2 Disconnect the cables.
3 Move the Drystar 5300 to its destination (2 persons!).
4 Reconnect the cables.
5 Switch Drystar 5300 on (refer to ‘Switching on the Drystar 5300’ on page 28).
Always keep in mind the following safety guidelines: