User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
152
2920B EN 20031206
Changing the film format of the trays
The key-operator can adjust the film size setting for both the input tray and
the output tray (either 14x17” or 11x14”).
First, the key-operator has to perform a mechanical modification. After this
modification, the ‘film format’ parameter is automatically read from the Film
Identification tag when the new film pack is loaded.
" By default, the Drystar 5300 is configured for 14x17”. The paragraphs
below describe the procedure to change the configuration to 11x14”. The
procedure for changing the configuration from 11x14” to 14x17” is similar.
Proceed as follows to perform the mechanical modification:
1 Take the output tray adjustment tool, and push it down into the output tray
holes to unlock the bracket position. Push the bracket forward until it clicks.
Remove the output tray adjustment tool.
1
2
Click!