User's Manual Part 2

131
2920B EN 20031206
The ‘Netmask’ screen is displayed:
If the netmask has already been assigned, it will be shown on the display.
7 Enter the netmask by means of the arrow keys. Refer to ‘Data entry’ on
page 27.
" Note that blank spaces will be ignored (see example).
Example: if the netmask is 255.255.255.0, then the data entry should be as follows:
8 Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
The ‘Router IP address’ screen is displayed:
If the Router IP address has already been assigned, it will be shown on the display.
9 Enter the Router IP address by means of the arrow keys. Refer to ‘Data entry’
on page 27.
" Note that blank spaces will be ignored (see examples on next page).
Example 1: if the IP address is 123.001.123.123, then the data entry should be as
follows:
Example 2: if the IP address is 123.1.123.123, then the data entry should be as
follows:
Netmask
255.255.255. 0
(255.255.255.255)
IN
Netmask
255.255.255. 0
(255.255.255.255)
IN
Router IP address
123.123.123.123
(255.255.255.255)
IN
Router IP address:
123.001.123.123
(255.255.255.255)
IN
Router IP address:
123. 1.123.123
(255.255.255.255)
IN