User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
125
2920B EN 20031206
Software installation from the previous version on the internal CF-card
This is the continuation from step 4 on page 123
5 Press the down key once, followed by the Confirm key to select ‘Previous SW
version’.
The printer restores the previous SW configuration from the internal CF-card:
6 When the copy operation is finished, the following screen is displayed (when
necessary):
7 Press the Confirm key to reset the printer. After the reset, the new settings
will be active.
Copying
C:/<path><filename>
to
C:/<path><filename>
IN
New settings will
be active after
reset
IN