User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
122
2920B EN 20031206
Installation operations
Two installation operations are possible:
• install new software, or upgrade existing software on the internal CF-card:
• ‘Software installation from an external CF-card’ (page 123),
• ‘Software installation from the previous version on the internal CF-card’
(page 125),
• perform a complete installation procedure, using the printer installation wizard.
Upgrading the software
It is possible to install new software or new software components onto the
internal CF-card.
Different software (components) can be installed:
• language files,
• modality specific files,
• output LUT,
• calibration files,
• ...
The new software will be activated after the installation procedure (this may
require a reset operation). The previously installed software components will
be automatically removed when installing new software or new data. A copy
of the previous configuration is saved (as a dataset) on the internal CF-card.
1 Press the Key-operator key to enter the key-operator mode.
2 On the key-operator main menu, press the Down key eight times, followed by
the Confirm key to select ‘Installation’.
The ‘Installation’ screen will be displayed:
3 Press the Confirm key to select ‘Software Installation’.
IN
1 Software
Installation
2Printer
installation