User's Manual Part 2
Table Of Contents
- Table of contents
- Introducing the Drystar5300
- Basic operation (Operator mode)
- Advanced operation (Key-operator mode)
- Overview of key-operator functions
- Viewing printer information
- Accessing the Show settings menu
- Viewing general information
- Viewing input tray information
- Viewing network (DICOM) information
- Viewing general image quality information
- Viewing default densitometer information
- Viewing image quality information of a modality
- Viewing installed data-sets information
- Viewing logical printers information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Maintaining optimal image quality
- Service actions
- Quality control procedure
- Installation operations
- Controlling the Drystar5300 via a remote PC (with browser)
- System description
- Preventive maintenance
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Index
103
2920B EN 20031206
Accessing the Calibration menu
1
Press the Key-operator key to enter the key-operator mode.
2 On the key-operator main menu, press the Down key five times followed by
the Confirm key to select ‘Calibration’.
The ‘Calibration’ menu is displayed:
" This menu is the starting point for calibrations (see below).
3 Press the Escape key to return to the key-operator main menu.
4 Press the Escape key to quit the key-operator mode.
CA
1 Film calibration
2 Therm. Head clean.