User's Manual Part 1
Table Of Contents
- Contents of the packages
- Remove the packing materials
- Remove Drystar5300 from pallet
- Unpack the accessories
- Environment specifications
- Remove transport protections (1 of 2)
- Remove transport protections (2 of 2)
- Adjust Input block module - 11x14” (1 of 2)
- Adjust Input block module - 11x14” (2 of 2)
- Connect the cables
- Load film in the input tray (1 of 2)
- Load film in the input tray (2 of 2)
- Startup Drystar5300
- Configure network settings
16/16
2923B EN 20031206
14 Configure network settings
2 Select and initiate film calibration.
Ask your network manager
the following information:
Printer IP address:
Netmask:
Router IP address:
Printer AE_Title:
Service Host IP address:
1. Press the Key-operator key.
2. Press the Down key five times.
3. Press the Confirm key twice.
4. Follow the instructions
(see Reference manual).
1x
5x
2x
SELECT
CALIBRATION
1 Film calibration
2 Therm. Head clean.
CA
1 Select and initiate the printer
installation wizard.
3 Your Drystar 5300 is ready for use!
1. Press the Key-operator key.
2. Press the Down key eight times.
3. Press the Confirm key.
4. Press the Down key.
5. Press the Confirm key.
6. Follow the instructions
(see Reference manual).
1x
8x
1x
1x
1x
1 Installation
from CF card
2 Printer
installation
IN
POWER
E
Network