User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
75
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Changing the assignment modality - output tray
1 Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure on
page 70 to select the ‘General’ screen.
2 On the ‘Change setting’ screen, press the Confirm key to select ‘General’.
The ‘General’ screen is displayed:
3 On the ‘General’ screen, press the Down key three times, followed by the
Confirm key to select ‘Assignment modal./tray’.
The ‘Assignment modal./tray’ screen is displayed:
4 Select a modality by using the select key and pressing Confirm.
The following window is displayed:
5 Use the Up/Down arrow keys to select the output trays for the particular
modality and press the Left/Right arrow keys to install button to uninstall/
install the output tray.
If you have selected more than one input tray, you must consecutively assign the
output trays.
The number of selections depends on the number of modalities defined.
An asterix left from an output tray indicates that the respective output tray is
installed.
1 <Modality name>
2 <Modality name>
3 <Modality name>
4 <Modality name>
5 <Modality name>
6 <Modality name>
7 <Modality name>
<Modality name>
*position 1 (upper)
position 2
position 3
p
osition 4
(
lower
)