User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
74
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Changing the sorter configuration
1 Perform steps 1 to 2 of the ‘Accessing the Change settings menu’ procedure on
page 70 to select the ‘General’ screen.
2 On the ‘Change setting’ screen, press the Confirm key to select ‘General’.
The ‘General’ screen is displayed:
3 On the ‘General’ screen, press the Down key twice, followed by the Confirm key
to select ‘Sorter Configuration’.
The ‘Sorter Configuration’ screen is displayed:
4 Use the Up and Down keys to select the output tray you wish to configure and
press the Left/Right arrow keys to install/uninstall the output tray.
5 Click OK to install the indicated output tray.
An asterix left from an output tray indicates that the respective output tray is
installed.
*position 1 (upper)
*position 2
position 3
*
p
osition 4
(
lower
)