User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
70
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Accessing the Change settings menu
Proceed as follows to access the ‘Change settings’ menu:
1 Press the Key-operator key to enter the Key-operator mode.
2 On the Key-operator main menu, press the Down key twice, followed by the
Confirm key to select ‘Change settings’.
The ‘Change settings’ screen is displayed:
3 Press the Escape key to return to the Key-operator main menu.
Image quality
‘Changing general image quality settings - Film calibration’ 91
‘Changing general image quality settings - Default densitometer’ 93
‘Changing Image quality setting for a modality - Selecting a lookup table’ 94
‘Changing Image quality setting for a modality - Changing the
Interpolation’
96
‘Changing Image quality setting for a modality - Changing the maximum
density (Dmax)’
98
If the printer has not yet been installed, the ‘printer installation wizard’ should be
executed first. In this case, the following screen is displayed: