User Manual

66
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Viewing general Image quality information
1 Perform steps 1 and 2 of the ‘Accessing the Show settings menu’ procedure, on
page 61.
2 On the Show settings menu, press the Down key four times, followed by the
Confirm key to select ‘Image quality’.
The following screen will appear:
3 Press the Confirm key to select ‘General’.
The general Image quality settings are displayed:
The following info is displayed:
• Film calibration setting: OFF/ON with the number of film packs
determining the calibration interval (if ON).
• Dmax upper tray: the maximum density for the upper input tray resulting
from the automatic film calibration.
• Dmax lower tray: the maximum density for the lower input tray resulting
from the automatic film calibration.
• TPH cleaning: the number of prints after the last thermal head cleaning,
and the number of prints to go before a new cleaning session is necessary.
• TPH profile: the number of prints after the last thermal head profile
calibration and the number of prints to go before a new thermal head
profile calibration is necessary.
• Def. densitometer: shows the default densitometer that is used for the
calibrations.
4 Press the Confirm key to return to the Image quality menu.
5 In the Image quality menu, press the Escape key to return to the Show settings
menu.
2 <Modality name>
3 <Modality name>
4 <Modality name>
5 <Modality name>
6 <Modality name>
7 <Modality name>
OFF
3.12
3.11
OFF
OFF
Macbet