User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
59
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Stopping the printing process
To stop the printing process on an adequate way, it is recommended to use the
Stop printing menu.
Accessing the Stop printing menu
1 Press the Key-operator key to enter the Key-operator mode.
2 On the Key-operator main menu, press the Confirm key to select ‘Stop printing’.
While the current print job is finished, the Stop Printing screen is displayed:
After the current print job is completed, the following screen is displayed:
3 Press the Confirm key to resume printing or press the Escape key to return to
the Key-operator main menu.
The modality name defined during installation will be used to refer to the
corresponding modality. In case there is also a nickname (daily used name) defined
during installation, the nickname is used.
<Modality name>> 10:21:34 PRINTING
1 2
Blinking
Blinking