User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
42
2900H EN 20071108Basic operation (operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Deleting print jobs
You can remove jobs from the print queue if they are in the ‘waiting status’.
Any pending jobs that are already being calculated or scheduled for printing
will be finished. Such jobs can not be deleted.
1 On the keypad, press the Delete key.
The Delete print job screen is displayed:
You can press the
Escape key to return to the previous menu without deleting print jobs
(‘Quit’).
2 Press the Down and Up keys to scroll through the jobs and press the Confirm
key to select the job that must be deleted.
The Confirm delete screen is displayed.
You can press the Escape key to return to the previous menu without deleting print
jobs (‘Cancel’).
Only the jobs that have the ‘waiting’ status are displayed.
On the print queue screen the modality name defined during installation
(nickname) will be used to refer to the corresponding modality. In case no
nickname has been defined during installation, this AE-title will be used.
If you want to delete all jobs at once, press the up/down arrow keys to select ‘All
jobs’, followed by the Confirm key. Proceed with the next step.
<Modality name>18-01-200511:07:18
<Modality name>18-01-200511:07:36
<Modality name>18-01-200511:07:18