User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
40
2900H EN 20071108Basic operation (operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
The other lines give information on the jobs that are still waiting in the print
queue. A description of the possible status of each job is listed in the table
below:
Status Description Action
Printing
Printing of this job is in
progress.
Wait.
Calculating
The necessary calculations
are being made before
printing of the job can be
started.
Waiting
The job has been put in the
print queue, but no
processing is yet being
done.
Wait.
• To put emergency jobs on top of
the queue, refer to ‘Assigning
emergency priority’ on page 41.
• To remove jobs from the queue,
refer to ‘Deleting print jobs’ on
page 42.
Media size
indication
No compatible media are
loaded for the print job.
Make sure the correct media are
loaded.
On the print queue screen the modality name defined during installation
(nickname) will be used to refer to the corresponding modality. In case no
nickname has been defined during installation, this AE-title will be used.
If the job status holds a warning or error indication, refer to ‘Error messages while
the printer starts up’ on page 218.